K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
2.3. Press in the ball joint using the tools as shown.
^
The ball joint will bottom on the control arm.
^
When installing the ball joint with the J 41435, make sure the notch in the tool aligns with the grease fitting.
3. Install the ball joint into the steering knuckle.
4. Install the stud nut onto the stud.
Tighten
^
Tighten the nut to 128 Nm (94 ft. lbs.).
^
Tighten in order to align the slot in the stud nut with the hole in the stud.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
5. Install a new cotter pin to the stud.
6. Install the drive axle (halfshaft).
7. Install the brake caliper.
8. Install the tire and wheel assembly.
Important: Check the front wheel alignment.
9. Lower the vehicle.
