K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
6. Install the pressure control solenoid retainer bolt and screw.
-
Tighten the TCC solenoid bolts/screws to 11 Nm (97 inch lbs.).
-
Tighten the pressure control solenoid bolt/screw to 11 Nm (97 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
7. Install the TCC PWM solenoid to the control valve body.
8. Install the TCC PWM solenoid retainer.
IMPORTANT: The piston legs must,face toward the case when installed.
9. Connect the component electrical connectors.