K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
10. Raise the vehicle. Support the vehicle with safety stands. Refer to Vehicle Lift Points.
11. Remove the cable retainer from the transmission mounted bracket. Squeeze the cable retainer while pulling the cable towards the rear of the
vehicle.
12. Disconnect the cable end from the transmission range select lever ball stud.
13. Position the transmission range select lever to PARK (P). Rotate the range select lever clockwise until the lever reaches the full clockwise stop
position.
14. Remove the range select lever cable from under the fuel line and from the rear transmission bracket.
15. Note the routing of the range select lever cable on the vehicle before removal.
16. Remove the safety stands.
17. Lower the vehicle.
18. Remove the range select lever cable grommet from the floor panel.
19. Remove the range select lever cable from the vehicle.
INSTALLATION PROCEDURE
