K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
7. Install the 1-2 accumulator piston seal onto the 1-2 accumulator piston.
IMPORTANT: The three legs on the piston must face toward the case when installed.
8. Install the 1-2 accumulator piston into the 1-2 accumulator cover and pin assembly
9. The 1-2 accumulator spring on the piston.
10. The 1-2 accumulator cover and pin assembly onto the case.
-
Tighten the bolts to 11 Nm (97 inch lbs.).
11. Install the new filter and gasket, pan bolts and new fluid.
12. Lower the vehicle.
13. Install the negative battery cable.
14. Adjust the fluid level. Use Dexron (R) III Automatic Transmission Fluid or the equivalent.
15. Inspect for leaks.
