K 2500 Truck 4WD V8-8.1L VIN G (2001)
1. Use the J 22102 in order to install the crankshaft sprocket.
Align the keyway of the crankshaft sprocket with the crankshaft pin.
2. Remove the J 22102.
3. Rotate the crankshaft until the crankshaft sprocket alignment mark is in the 12 o'clock position.
Important:
^
Install the camshaft sprocket with the alignment mark in the 6 o'clock position.
^
The sprocket teeth must mesh with the timing chain in order to prevent damage to the camshaft retainer.
^
Do not use a hammer to install the camshaft sprocket onto the camshaft. To do so may damage the camshaft.
4. Install the camshaft sprocket and timing chain.
5. Ensure that the crankshaft sprocket is aligned at the 12 o'clock position and the camshaft sprocket is aligned at the 6 o'clock position.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the camshaft sprocket bolts.
6.1.
Tighten the camshaft sprocket bolts a first pass to 30 Nm (22 ft. lbs.).
6.2.
Tighten the camshaft sprocket bolts a final pass to 30 Nm (22 ft. lbs.).
