K 2500 Truck 4WD V8-8.1L VIN G (2001)
Wheel Fastener: Service and Repair
Rear
Wheel Stud Replacement
^
Tools Required
-
J 43631 Ball Joint Separator
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
3. Remove the rotor. Refer to Brake Rotor Replacement - Rear in Brakes and Traction Control.
4. Remove the wheel stud from the axle flange using the J 43631 (15 series).
5. Remove the axle shaft (vehicles with 9.5 in ring gear). Refer to Rear Axle Shaft Replacement.
6. Remove the rear hub assembly (vehicles with 10.5 in ring gear). Refer to Rear Axle Shaft Replacement.
7. Remove the wheel stud from the axle flange using the J43631.
8. Remove the wheel stud from the hub flange using the J43631.
Installation Procedure
1. Install the stud into the axle flange (15 Series).
2. Install the 4 washers and the lug nut to the stud.