K 2500 Truck 4WD V8-8.1L VIN G (2001)
17.
Assemble the Universal Puller J 24420-B, with three legs J 43910.
18.
Place the puller into position and remove the ball bearing from the case and the output shaft. Save the bearing.
19.
Locate the selective spacer and discard.
20.
Remove the four bolts numbered (1).
21.
Remove the twelve bolts numbered (2).
Important:
When removing the rear extension housing, it is possible for the park pawl support pin to be removed with the rear extension housing.
22.
Separate the rear extension housing (1) from the transmission case (3). The extension housing has places for insertion of a small pry bar at two