K 2500 Truck 4WD V8-8.1L VIN G (2001)
1. Position the rear output shaft seal in the transfer case.
2. Using the J 37668-A, install the front output shaft in the transfer case.
3. Install the rear propeller shaft.
^
For vehicles equipped with the one piece propeller shaft, refer to Propeller Shaft Replacement - One Piece.
^
For vehicles equipped with the two piece drive shaft, refer to Propeller Shaft Replacement Two Piece.
4. Check the fluid level.
5. Install the transfer case shield to the cross member.
6. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case Output Shaft Seal Replacement - Front
Transfer Case Output Shaft Seal Replacement - Front
^
Tools Required
-
J 8092 Universal Handle
-
J 43484 Front Output Shaft Seal Installer
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield from the crossmember (if equipped).
3. Remove the front propeller shaft from the vehicle.
4. Insert a flat-tipped screw driver in the inner race.
5. Pry the inner race back.
