K 2500 Yukon 4WD V8-6.0L VIN U (2000)
1. Install the handle to the vehicle.
2. If the lock cylinder is a replacement, apply a coating of GM P/N 12345120 or Canadian P/N 726548 or a similar lubricant to the inside of the lock
case and the cylinder keyway.
3. Install the door lock cylinder to the outside handle housing.
In order to code a new lock cylinder. Refer to Key and Lock Cylinder Coding .
4. Install the lock cylinder clip to the lock cylinder rod.
5. Install the handle rod to the handle assembly clip.
6. Remove masking tape from door handle.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the outside handle mounting nuts.
Tighten the nuts to 9 N.m (80 lb in).
8. Install the rubber cover.
9. Install the water deflector.
10. Install the trim panel.
