K 2500 Yukon 4WD V8-6.0L VIN U (2000)
Rear Door Window Regulator: Service and Repair
Door Window Regulator Replacement (Power)
REMOVAL PROCEDURE
The power window motor cannot be serviced. Replace the power window motor as a unit with the regulator.
1. Raise and support the window glass.
2. Remove the trim panel.
3. Remove the water deflector.
4. Disconnect the harness from the electric window motor assembly.
5. Remove the 2 bolts holding the glass to the regulator.
6. Remove the bolts from the window regulator.
7. Remove the window regulator assembly from the door folding both sides together.
INSTALLATION PROCEDURE
1. Install the regulator to the door.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolts to the window regulator.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
3. Align the window glass to the regulator and install the bolts holding the glass to the regulator.
