K 2500 Yukon 4WD V8-6.0L VIN U (2000)
Hood Latch Release Cable: Service and Repair
Hood Primary Latch Release Cable Replacement
Removal Procedure
Important: If the cable is broken, release the hood by pressing the latch tab on the left side of the lock assembly. Use a rod to press the latch tab.
1. Lift the hood.
2. Remove the left hinge pillar trim panel.
3. Remove the cable handle underneath the instrument panel (IP).
4. Remove the cable end from the handle.
1. Use needle nose pliers in order to squeeze the tabs in order to remove the cable end from the hood latch assembly.
2. Lift the cable from the lock.
5. Pull the cable in toward the cable handle through the hole in the cowl.
6. Detach the cable from the retainer clips.