K 2500 Yukon 4WD V8-6.0L VIN U (2000)
Seat Cushion: Service and Repair
Rear Seat Back Cushion Cover and Pad Replacement (Tahoe/Yukon 50/50 Split - 2nd Rear)
Rear Seat Back Cushion Cover and Pad Replacement (Tahoe/Yukon 50/50 Split - 2nd Rear)
Removal Procedure
1. Remove the quick release latch plates for the lap/shoulder belts by pressing a drift punch or a similar tool into the release hole of the seat belt
buckle while pulling on the safety belt.
2. Pull up on the handle at the rear of the seat.
3. Roll the seat forward.
4. Lift the seat up and out of the floor rails.
5. Remove the seat from the vehicle.
Installation Procedure
1. Install the seat into the vehicle.
2. Align the seat attaching points with the slots in the floor rail.
3. Push the seat forward in the rail in order to lock the front of the seat risers onto the pins on the inside of the floor rail.
4. Roll the seat back and down in order to secure the seat into place.
5. Install the quick release latch plate for the lap/shoulder belt by inserting the latch plate into the seat belt buckle and pushing in order to engage the
latch plate with the seat belt buckle.
