K 2500 Yukon 4WD V8-6.0L VIN U (2000)
1. Install the brake hose. Do not twist the hose when installing the hose.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the brake hose mounting bolt and new compression washers at the caliper.
^
Tighten the bolt to 45 N.m (33 lb ft).
3. Install the brake hose bolt and the bracket to the steering knuckle.
^
Tighten the bolt to 9 N.m (80 lb in).
4. Install the brake hose bolt and the bracket to the upper control arm.
^
Tighten the bolt to 9 N.m (80 lb in).
5. Install the brake hose bolt to the frame.
^
Tighten the bolt to 12 N.m (106 lb in).
6. Install the brake hose retaining clip.
7. Connect the brake pipe.
^
Tighten the bolt to 25 N.m (18 lb ft).
8. Bleed the brake system. Refer to Automated Bleed Procedure.
9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
10. Remove the safety stands.
11. Lower the vehicle.