K 2500 Yukon 4WD V8-6.0L VIN U (2000)
Cruise Control Servo Cable: Service and Repair
Cruise Control Cable Replacement
REMOVAL PROCEDURE
1. Remove the engine sight shield.
2. Disconnect the cruise control cable locator clip from the outboard rectangular hole in the routing bracket at the left front corner of the engine.
3. Disconnect the cruise control cable conduit fitting from the round hole in the engine cable bracket.
IMPORTANT: Do not remove the C clip from the cruise control connector. The C clip was not designed for removal. Damage may occur when
removing.
4. Disconnect the cruise control cable engine-end fitting from the stud on the throttle lever.
5. Disconnect the cruise control cable fitting from the cruise control module.
