K 2500 Yukon 4WD V8-6.0L VIN U (2000)
1. Install the lower engine mount to the frame.
2. Install the through bolts.
3. Tighten the through bolts finger tight.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the upper engine mount and the bolts to the engine.
Tighten the bolts to 50 Nm (37 ft. lbs.).
5. Remove the engine support and lower the vehicle.
6. Install the three bolts holding the upper and the lower engine mounts together.
Tighten the bolts to 50 Nm (37 ft. lbs.).
7. Raise the vehicle.
