K 2500 Yukon 4WD V8-6.0L VIN U (2000)
1. Install the air inlet actuator.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the air inlet actuator retaining screws.
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connector to the air inlet actuator (1).
4. Install the passenger side air bag.
5. Install the IP lower trim panel and the glove box assembly.
6. Install the IP upper trim panel.
7. Inspect the system for proper operation.
Mode Actuator Replacement
REMOVAL PROCEDURE
