K 2500 Yukon 4WD V8-6.0L VIN U (2000)
CAUTION: Refer to Approved Container Caution in Cautions and Notices.
7. Clean the fuel sender sealing surfaces.
INSTALLATION PROCEDURE
CAUTION: Refer to Fuel sender gasket caution in Cautions and Notices.
1. Install the new seal on the fuel tank.
IMPORTANT: The fuel pump strainer must be in a horizontal position when the fuel sender is installed in the tank. When installing the fuel sender
assembly, assure that the fuel pump strainer does not block full travel of the float arm.
2. Install the fuel sender assembly into the fuel tank.
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Install the fuel sender assembly retaining ring using the J 44402 fuel tank sending unit wrench.
4. Install the fuel tank.
5. Refill the fuel tank.
