K 2500 Yukon 4WD V8-6.0L VIN U (2000)
Backup Lamp Switch: Service and Repair
Manual Transmission - NV 3500
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Disconnect the backup lamp switch electrical connector.
3. Remove the backup lamp switch.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the backup lamp switch.
The backup lamp switch has pre-applied thread sealant on the threads.
Tighten the backup lamp switch to 28 Nm (21 ft. lbs.).
2. Connect the backup lamp switch electrical connector.
3. Lower the vehicle.