K 2500 Yukon 4WD V8-6.0L VIN U (2000)
Manifold Absolute Pressure (MAP) Sensor: Service and Repair
REMOVAL PROCEDURE
1. Loosen the fasteners from the intake manifold sight shield.
2. Remove the sight shield.
3. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector.
4. Remove the MAP sensor (1) from the intake manifold.
INSTALLATION PROCEDURE
IMPORTANT: Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.
1. Install the MAP sensor (1). Push the MAP sensor down in order to engage the sensor into the retainer.
