K 2500 Yukon 4WD V8-6.0L VIN U (2000)
INSTALLATION PROCEDURE
1. Install the PCM (4) to the PCM mounting bracket (7) ensuring that the mounting tabs (3) are engaged.
2. Secure the spring latch (2) to the PCM.
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Connect the PCM connectors (6) to the PCM (4).
Tighten
Tighten the PCM connector end fasteners to 8 N.m (70 lb in).
4. Install the PCM cover (8) to the PCM mounting bracket (7), ensuring the mounting tabs on the PCM mounting bracket are engaged into the
mounting holes in the PCM cover.
5. If a new PCM is being installed, program the EEPROM. See: Testing and Inspection/Programming and Relearning
