K 2500 Yukon 4WD V8-6.0L VIN U (2000)
5. Remove the TP sensor (6).
6. Remove the TP sensor O-ring seal (7).
INSTALLATION PROCEDURE
1. Install the TP sensor O-ring seal (7) on the TP sensor (6).
2. Install the TP sensor on the throttle body with the throttle valve in the closed position. Make sure the TP sensor lever lines up with the TP sensor
drive lever on the throttle shaft.
NOTE: Refer to the Fastener Notice in Cautions and Notices.
3. Install the TP sensor attaching screws (5).
Tighten
Tighten the screws to 2 N.m (18 lb in).
4. Connect the TP sensor electrical connector.
