K 2500 Yukon 4WD V8-6.0L VIN U (2000)
1. Remove the caps from the fuel sender EVAP pipe and the fuel tank roll over valve.
2. Connect the rear EVAP pipe (1) to the fuel sender (2), the fuel tank roll over valve (3), and the fuel tank clips (6).
3. Install the fuel tank.
4. Lower the vehicle.
5. Refill the fuel tank.
6. Connect the negative battery cable.
7. Tighten the fuel filler cap.
8. Inspect for leaks.
8.1. Turn the ignition ON for 2 seconds.
8.2. Turn the ignition OFF for 10 seconds.
8.3. Turn the ignition ON.
8.4. Inspect for fuel leaks.
