K 2500 Yukon 4WD V8-6.0L VIN U (2000)
4.
Remove the fuse box cover from the left end of the instrument panel (IP).
5.
Remove the AIR BAG fuse from the fuse block.
6.
Remove the CPA (1) from the driver side air bag yellow 2-way connector and disconnect the connector (2) located on the IP lower tie bar brace.
7.
Open the IP compartment door and remove all customer materials. Depress the limit stop on the right side of the IP compartment in order to allow
the door to swing completely open.
Looking in the smaller opening at the top of the IP, you will notice a large metal bar running cross-vehicle (4). On the back side of this bar is the
passenger side inflator module yellow 2-way connector (2). Using a small pry bar, disengage the retainer from the bar allowing the passenger side
inflator module yellow 2-way connector to hang loose. Remove the CPA from the passenger side inflator module yellow 2-way connector and
disconnect the connector.
