gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Recall - Air Bag Sensing Diagnostic Module Anomaly|Page 12866 > < Recall - Air Bag Sensing Diagnostic Module Anomaly|Page 12864
Page 4
background image

Important

The air bag system must be functioning properly before performing this recall service procedure. If the air bag system is not functioning properly and
diagnosis, repairs, and/or parts are necessary, charge it to regular warranty labor codes and times.

1.

Turn the ignition switch to the "ON" position and verify that the "AIR BAG" warning lamp flashes seven (7) times and then turns "OFF".

^

If the "AIR BAG" warning lamp does not operate as described, perform the SIR Diagnostic System Check as described in the appropriate
manual before proceeding.

2.

Connect the Tech 2 to the vehicle's Data Link Connector (DLC) located under the instrument panel near the parking brake lever.

3.

Turn the Tech 2 "ON" by pressing the power button.

4.

Select "Diagnostics" on the "Main Menu" screen.

5.

Select the "2000" model year and "LD Trk, MPV, Incomplete" on the "Vehicle Identification" screens.

6.

Select "Body" on the "System Selection Menu" screen.

7.

Select the letter "C" (for two wheel drive vehicle) or "K" (for four wheel drive vehicle) on the "Vehicle Identification Product Line" screen.

8.

Confirm that the ignition switch is still in the "ON" position (engine not running).

9.

Select "Supplemental Inflatable Restraint" on the "Body" screen.

10.

Select "Special Functions".

11.

Select "SDM Reprogramming".

Important

If the vehicle has previously had the SDM replaced with an updated version, the Tech 2 will display "Controller Does Not Require Recalibration". If
this screen is displayed, press the "Exit" button on the Tech 2 and proceed to step 14.

12.

When programming is complete, the Tech 2 will display "Procedure Complete".

13.

After reprogramming is complete, press the "Exit" button on the Tech 2.

14.

Turn the ignition switch to the "OFF" position and disconnect the Tech 2 from the vehicle's DLC.

15.

Turn the ignition switch to the "ON" position and verify that the "AIR BAG" warning lamp flashes seven (7) times and then turns "OFF".

16.

Install the GM Recall Identification Label.

Recall - Air Bag Sensing Diagnostic Module Anomaly|Page 12866 > < Recall - Air Bag Sensing Diagnostic Module Anomaly|Page 12864