K 2500 Yukon 4WD V8-6.0L VIN U (2000)
29. Route the deployment harness out of the driver side of the vehicle.
30. Disconnect the inflatable restraint IP module yellow 2-way harness connector (1) located behind the glove box door (3).
31. Cut the harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
32. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
33. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used to fabricate the passenger
deployment harness.
34. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
