K 2500 Yukon 4WD V8-6.0L VIN U (2000)
22.
Confirm that the belt is properly routed.
23.
Install the hoses.
24.
Install the electrical connector to the EVO actuator.
Important:
Hoses touching the frame, body or engine may cause system noise.
25.
Verify that the hoses do not touch any other part of the vehicle.
Important:
Loose connections may not leak, but could allow air into the steering system.
26.
Verify that all hose connections are tight.
Important:
Maintain the fluid level throughout the bleed procedure.
27.
Remove the pump reservoir cap.
Important:
Use clean, new power steering fluid only.
28.
Fill the pump reservoir with fluid to the FULL COLD level.
29.
Attach the J 43485 to the J 35555 or equivalent.
30.
Place the J 43485 on or in the pump reservoir filler neck.
31.
Apply a vacuum of 68 kpa (20 in Hg) maximum.
32.
Wait 1 minute.
33.
Remove the J 43485 and the J 35555.
34.
Reinstall the pump reservoir cap.
35.
Start the engine. Allow the engine to idle.
36.
Turn the steering wheel 180-360 degrees in both directions 5 times.
37.
Switch the ignition off
38.
Verify the fluid level.
G Van Repair Procedure
Tools Required
