K 2500 Yukon 4WD V8-6.0L VIN U (2000)
18.
Remove the power steering pump pulley.
A.
Install the J 25034-C pulley remover.
B.
Be sure the pilot bolt bottoms in the pump shaft by turning the nut to the top of the pilot bolt.
C.
Hold the pilot bolt.
D.
Turn the nut counterclockwise.
19.
Remove the air conditioning compressor mounting bolts and support compressor with wire.
20.
Remove upper radiator hose support bracket.
21.
Remove power steering pump bolts (5).
22.
Remove power steering pump bracket (1).
23.
Remove the reservoir hose from the pump.
24.
Loosen adjusting nuts (4).
25.
Remove pressure line from pump and raise it to prevent drainage.
26.
Remove the return line from the pump and raise it to prevent drainage.
27.
Cap the ends of the hoses to prevent entry of dirt.
28.
Remove the electrical connector from EVO actuator, if equipped.
29.
Remove the pump.
30.
Perform the following on EVO equipped pumps only:
^
Mark the orientation of the EVO on the pump.