K 2500 Yukon 4WD V8-6.0L VIN U (2000)
A.
Remove the EVO actuator and discharge fitting from the original pump.
B.
Remove the 0-ring seal from the EVO actuator and properly discard.
C.
Remove the fitting assembly from the replacement pump and carefully remove the 0-ring seal before properly discarding the fitting.
D.
Lubricate new 0-ring seal removed from the replacement pump fitting with clean power steering fluid and install in correct groove in the
EVO actuator.
E.
Install the original EVO actuator and discharge fitting on the replacement pump noting the correct orientation.
Tighten
Tighten the EVO actuator assembly to 50 Nm (37 lb-ft.).
31.
Transfer rear bracket to replacement pump.
32.
Install the new pump on the rear mounting studs.
Notice:
Refer to Fastener Notice in Cautions and Notices.
33.
Install the pressure line to the pump.
34.
Tighten the fitting.
Tighten
Tighten to 27 Nm (20 lb-ft).
35.
Install the return line to the pump.
36.
Install reservoir hose to the pump.
37.
Install the power steering pump bracket.
