K 2500 Yukon 4WD V8-6.0L VIN U (2000)
1. Install the rear servo assembly to the transmission case as follows:
1.1. Accumulator spring (74).
1.2. Selective pin (73).
1.3. Servo spring retainer (72).
1.4. Servo spring (71).
1.5. Washer (70).
1.6. Piston seal (69).
1.7. Accumulator piston (68).
1.8. Inner ring oil seal (67).
1.9. Outer ring oil seal (66).
1.10. Servo piston (65).
1.11. Bottom retaining clip (64).
1.12. Cover gasket (63).
1.13. Cover (62).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the cover bolts (61).
Tighten the bolts to 24 Nm (18 ft. lbs.).
3. Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid/Filter Changing.
Forward Servo Replacement
Removal Procedure
