K 2500 Yukon 4WD V8-6.0L VIN U (2000)
31. Install the TCC regulator apply valve spring (3).
32. Install the TCC regulator apply valve (2).
33. Install the TCC regulator apply valve pin (4).
34. Install the TCC PWM solenoid valve (1).
35. Install the TCC PWM solenoid valve retainer (5).
36. Install the pressure control solenoid valve (1) with the electrical connector facing away from the control valve body.
37. Install the pressure control solenoid clamp (2).
38. Install the pressure control solenoid clamp bolt (3).
Tighten the bolt to 8 Nm (71 inch lbs.).
Installation Procedure
1. Install the 8 checkballs (9 checkballs for some models) into the control valve body.
^
The checkball marked as number 2, is used on RCP, RDP, ZJP and ZLP models only
