K 2500 Yukon 4WD V8-6.0L VIN U (2000)
1. Verify that the splines of the transfer case are coated with sufficient grease. If not, use special Teflon grease (GM P/N 9985830). Refer to Fluid
and Lubricant Recommendations.
2. Place the new clamp in the groove of the propeller shaft boot.
3. Install the propeller shaft splines into the transfer case output shaft.
4. Install the boot onto the transfer case output shaft until the boot snaps into the groove on the OD of the output shaft.
5. Crimp the clamp using the J 43218 according to the crimping specifications.
6. Install the propeller shaft (5) to the front axle flange (1).
7. Line up the reference marks made previously.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install the yoke retainers (7) and the bolts (6).
Tighten the yoke retainer bolts to 25 Nm (19 ft. lbs.).
9. Install the transfer case shield. Refer to Shield Replacement.
10. Lower the vehicle.