K 2500 Yukon 4WD V8-6.0L VIN U (2000)
22. Use a new dauber in order to apply the glass primer (black #2) to the same areas (2) that glass prep (clear #1) was applied.
The glass primer (black #2) is good up to 8 hours after applying it to the glass. The primed surface of the glass must be kept clean.
23. Allow the glass primer to dry for approximately 10 minutes.
24. If using the short method, cut the tip of the applicator nozzle in order to provide a bead of 6.0 mm (1/4 in).
25. If using the extended method, cut the applicator nozzle in order to provide a bead of 12.7 mm (1/2 in) wide and 12.7 mm (1/2 in ) high.
26. Use a cartridge type caulking gun to apply a smooth, continuous bead of urethane adhesive.
27. When using the short method, apply the urethane adhesive to the existing bead of urethane adhesive on the body.
28. When using the extended method, use the edge of the windshield window or the inside edge of the reveal molding as a guide for the nozzle in
order to apply the urethane adhesive (1) to the inner surface of the windshield window (3).
If applying urethane adhesive to the inside edge of the windshield reveal molding (1) use the windshield reveal molding as a guide for the nozzle.
