K 2500 Yukon XL 4WD V8-8.1L VIN G (2001)
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield.
3. Remove the rear propeller shaft.
^
For vehicles equipped with the one piece propeller shaft, refer to Propeller Shaft Replacement - One Piece.
^
For vehicles equipped with the two piece propeller shaft, refer to Propeller Shaft Replacement - Two Piece.
4. Remove the transfer case rear output shaft seal.
Installation Procedure
Important: When installing the rear output shaft seal in the transfer case, make sure that the locating tab should be facing up.
1. Position the rear output shaft seal in the transfer case.
2. Using the J 37668-A, install the rear output shaft to the transfer case.
3. Install the rear propeller shaft.
^
For vehicles equipped with the one piece propeller shaft, refer to Propeller Shaft Replacement - One Piece.
^
For vehicles equipped with the two piece propeller shaft, refer to Propeller Shaft Replacement - Two Piece.
4. Check the transfer case fluid level.
5. Install the transfer case shield.
6. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case Output Shaft Seal Replacement - Front
Transfer Case Output Shaft Seal Replacement - Front
^
Tools Required
-
J 8092 Universal Drive Handle
-
J 43484 Front Output Shaft Seal Installer
Removal Procedure
