K 2500 Yukon XL 4WD V8-8.1L VIN G (2001)
Shifter Transfer Case: Service and Repair
Transfer Case Control Rod Replacement
Transfer Case Control Rod Replacement
Removal Procedure
Important: Before starting the following service procedure, position the automatic transmission in the PARK POSITION. If the vehicle that is being
serviced is equipped with a manual transmission, position the transmission in FIRST GEAR and place the transfer case in 2 HI POSITION.
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield.
3. Remove the front propeller shaft.
Important: When performing this service procedure, use a small pocket screw driver to release the retaining clip on the ends of the transfer case
control shift rod.
4. Remove the transfer case control rod from the transfer case shift control lever.
5. Remove the transfer case control rod from the transfer case shift lever.
6. Remove the transfer case control rod.
Installation Procedure
Important:
^
Before installing the new transfer case control rod, loosen the adjuster nut on the transfer case control rod so it slides with slight resistance.
^
When installing the control rod on the control levers, a snap sound should heard or felt upon installation.
