K 3500 Truck 4WD V8-454 7.4L VIN N TBI (1995)
Throttle Body: Service and Repair
Fuel Meter Cover Assembly
Fuel Meter Cover
PROCEDURE
The fuel meter cover assembly contains the fuel pressure regulator assembly. The regulator has been adjusted at the factory and should only be
serviced as a complete preset assembly.
WARNING: DO NOT remove the four screws securing the pressure regulator to the fuel meter cover. The fuel pressure regulator
includes a large spring under heavy compression which, if accidentally re eased, could cause personal injury. Disassembly might also
result in a fuel leak between the diaphragm and the regulator container.
REMOVE OR DISCONNECT
1. Electrical connectors to fuel injectors. (Squeeze plastic tabs and pull straight up.)
2. Long and short fuel meter cover screw assemblies. Inspect For dirt, foreign material and casting warpage.
INSTALL OR CONNECT
1. New pressure regulator seal, fuel meter outlet passage gasket, and cover gasket.
2. Fuel meter cover assembly.
3. Attaching screw assemblies, precoated with appropriate locking compound to threads. (Short screws are next to injectors.) Tighten Screw
assemblies to 3.0 Nm (28.0 lb. in.).
4. Electrical connectors to fuel injectors.
5. With engine "OFF," and ignition "ON," check for leaks around gasket and fuel line couplings.
