K 3500 Truck 4WD V8-454 7.4L VIN N TBI (1995)
not as yet have received the notification letter.
In summary, whenever a vehicle subject to this campaign enters your vehicle inventory, or is in your dealership for service in the future, please take the
steps necessary to be sure the campaign correction has been made before selling or releasing the vehicle.
If the name and address of the owner of an involved vehicle was unavailable to GMC Truck Division at the time of campaign initiation, the dealer must
determine the owner's name and address from the dealership sales records. Please provide this information directly on the second copy of the listing next
to the applicable VIN so that our records may be updated and the appropriate notification mailed to the owner. This second copy should then be
submitted to the address listed below in the previously supplied yellow campaign envelopes.
GMC Truck Division
General Motors Corporation
101 Union Street
Plymouth, Michigan 48170
OWNER NOTIFICATION
Owners will be notified of this campaign on their vehicles by GMC Truck Division (see copy of owner letter included with this bulletin). A listing of
owner names and addresses has been furnished to the involved dealers to enable dealers to follow up with owners involved in this campaign. This listing
may contain owner names and addresses obtained from State Motor Vehicle Registration records. The use of such motor vehicle registration data for any
other purpose is a violation of law in several states. Accordingly, you are urged to limit the use of this listing to this campaign.
Service Procedure
1.
With the key in the On position, move the transmission shift lever to engage each transmission detent position (P, R, N, O/D, D, 2, 1).
-
If one or more transmission detent positions cannot be obtained (no shift indicator light) proceed to Shift Cable Adjustment Procedure below.
2.
Place the transmission lever in Park, turn the key to the lock position and raise the vehicle on a hoist.
3.
Verify that the lock button is in the locked position as shown in Figure 1.
4.
Install the clip to cover the lock button as shown in Figure 2.
