K 3500 Truck 4WD V8-5.7L VIN R (1998)
Installation Procedure
1. Install the regulator to the inner panel
2. Using the J 34940, install the rivets securing the regulator to the door inner panel.
3. Install the inner mounting panel assembly.
4. Install the water deflector.
5. Install the trim panel.
6. Connect the negative battery cable.
Window Regulator Handle Replacement
Removal Procedure
Tools Required
J 9886-01 Door Handle Remover
1. Remove the window regulator handle (1) from vehicle by completing the following steps:
1.1 Insert the J 9886-01 between the handle and the bearing plate.
1.2 Align the tool.
1.3 Push the tool in order to disengage the clip.
1.4 Pull the handle from the door.
2. Remove the bearing plate.
Installation Procedure
1. Install the bearing plate to the door.
2. Install the window regulator handle (1) by completing the following steps:
2.1 Raise the window.
2.2 Install the clip onto the handle.
2.3 Insert the handle onto the window regulator shaft so that the handle points toward the front of the door.
2.4 Push the handle until the clip engages the window regulator shaft.