K 3500 Truck 4WD V8-5.7L VIN R (1998)
Description
17. Route the deployment harness out of the vehicle's driver side.
Figure 27
18. Disconnect the inflatable restraint IP module yellow 2-way harness connector.
19. Cut the harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
20. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
21. Out two 6.1 M (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used to fabricate the passenger
deployment harness.
22. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
23. Twist together one end from each of the wires in order to short the wires.
24. Twist together one connector wire lead to one deployment wire.
