K 3500 Truck 4WD V8-5.7L VIN R (1998)
and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications.
Following these instructions can help you avoid damage to parts and systems.
-
Adjust the over-center torque by turning the pitman shaft adjuster screw clockwise until the correct preload torque is obtained. Add 0.7-1.1
Nm (6-10 inch lbs.) torque to the previously measured worm bearing preload torque.
-
Tighten the adjuster lock nut (8) to 49 Nm (36 ft. lbs.).
-
Prevent adjuster screw from turning while tightening adjuster lock nut (8).
8. Install steering gear.
Pitman Shaft and Side Cover Replacement
