K 3500 Truck 4WD V8-5.7L VIN R (1998)
Suspension Strut / Shock Absorber: Service and Repair
Rear Suspension
REMOVAL PROCEDURE
NOTICE: Original equipment shock absorbers serve additionally as suspension drop cutoffs. Replacement shock absorbers must have a built in
suspension cutoff feature and mutest not He longer than original shocks when they are fully extended or serious vehicle or component damage could
result
1. Raise the vehicle on a hoist.
2. Remove the following parts from the frame bracket:
^
The upper shock nut (5)
^
The bolt (6)
3. Remove the folly wing parts from the axle
^
The lower shock nut (1)
^
The washer (2)
^
The bolt (3)
4. Remove the shock absorber (4) from the vehicle.
INSTALLATION PROCEDURE
1. Install the shock absorber (4) to the vehicle.
2. Install the following parts:
2.1. The lower shock bolt (3)
2.2. The washer (2)
2.3. The lower nut (1)
Tighten
Tighten the lower nut to 100 Nm (74 ft. lbs.).
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or