K 3500 Truck 4WD V8-5.7L VIN R (1998)
17. Inspect the propeller shaft for any evidence of damage.
INSTALLATION PROCEDURE
1. Verify that the splines of the transfer case are coated with sufficient grease. If not, use special Teflon (R) grease (GM P/N 12345879).
2. Place the new clamp in the groove of the propeller shaft boot.
3. Install the propeller shaft splines into the transfer case output shaft.
4. Install the boot onto the transfer case output shaft until the boot snaps into the groove on the OD of the output shaft.
5. Install the propeller shaft to the front axle.
5.1.
Line up the reference marks made previously.
5.2.
Install the propeller shaft to the flange.
6. Install the retainers and bolts.
-
Tighten the retainer bolts to 20 Nm (15 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
7. Install the transmission control lever to the manual control shaft with the nut.
-
Tighten the transmission control lever nut to 28 Nm (21 ft. lbs.).
8. Crimp the clamp with J43218 according to crimping specifications.
