K 3500 Truck 4WD V8-5.7L VIN R (1998)
7. Remove the boot clamp at the transfer case end by prying up the exposed end of the clamp with a flat bladed tool.
8. Reference mark the relationship of the propeller shaft to the front axle.
IMPORTANT: Observe and accurately reference mark all driveline components relative to the propeller shaft and axles before disassembly.
These components include the propeller shafts, drive axles, pinion flanges, output shafts, etc. All components must be reassembled in the exact
relationship to each other as they were when removed. In addition, published specifications and torque values, as well as any measurements made
prior to disassembly must be followed.
9. Remove the bolts and the retainers from the front axle.
10. Rotate the front axle yoke (1) until the retainer ends are at the 2:00 and 8:00 positions.
11. Slide the propeller shaft rearward enough to disengage.
12. Disengage the propeller shaft by moving it rearward.
NOTICE: When removing the propeller shaft, do not attempt to remove the shaft by pounding on the yoke ears or using a tool between the yoke
and the universal joint. If the propeller shaft is removed by using such means, the injection joints may fracture and lead to premature failure of the
joint.
