K 3500 Truck 4WD V8-5.7L VIN R (1998)
Drive/Propeller Shaft: Specifications
Propeller Shaft Runout Specifications
Front Check
One Piece ............................................................................................................................................................................................................ 0.25 inch
Two Piece
Front Piece .................................................................................................................................................................................................... 0.25 inch
Rear Piece ................................................................................................................................................................................................................... -
Center Check
One Piece .......................................................................................................................................................................................................... 0.050 inch
Two Piece
Front Piece ................................................................................................................................................................................................ 0.005 inch *
Rear Piece ............................................................................................................................................................................................... 0.030 inch **
Rear Check
One Piece .......................................................................................................................................................................................................... 0.025 inch
Two Piece
Front Piece .................................................................................................................................................................................................................. -
Rear Piece .................................................................................................................................................................................................... 0.030 inch
*
This measurement must be taken on the ground surface near the spline with the rear propeller shaft removed.
** This measurement must be taken with the rear propeller shaft mounted on the front shaft which is within specifications.