K 3500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
INSTALLATION PROCEDURE
1. Using Locktite Cleaning Solvent 755, or equivalent, clean the mounting surfaces of the lower control arm ball joint and the new ball joint prior to
installation. Do not apply solvent to the ball joint seal.
2. Install the new ball joint into the lower control arm.
2.1. Apply a 6 mm (1/4 inch) bead of Locktite 680 evenly to the serrations on the ball joint prior to installation.
2.2. Position the ball joint in the control arm with the grease fitting toward the rear of the vehicle.
2.3. Press in the ball joint using the tools as shown.
-
The ball joint will bottom on the control arm.
-
When installing the ball joint with the J 41435, make sure the notch in the tool aligns with the grease fitting.
3. Install the ball joint into the steering knuckle.
4. Install the stud nut onto the stud.
-
Tighten the nut to 128 Nm (94 ft. lbs.). Tighten in order to align the slot in the stud nut with the hole in the stud.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install a new cotter pin to the stud.
6. Install the halfshaft.
7. Install the brake caliper.
8. Install the tire and wheel assembly.
9. Lower the vehicle.
Important: Check the front wheel alignment.
