K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
9. Install the stud, GM P/N 15017230, supplied with the service hinge, into the wire end. Pull the stud into position.
10. Hold the stud in position with the hinge and remove the fish wire.
11. Draw the stud (4) tight through the pillar. Use the nuts GM P/N 11516746, supplied.
12. Repeat steps 7 through 10 on the remaining stud locations.
13. Remove each service nut.
14. Apply a full-bodied caulk to the entire hinge mounting surface in order to ensure a proper seal.
15. Install the hinge (2) to the pillar (3). Use the supplied nuts (1).
NOTE: Refer to Fastener Notice in Service Precautions.
16. Install the hinge (2) to the pillar (3). Use the supplied nuts (1).
Tighten
Tighten the hinge nuts (4) to 25 N.m (18 lb ft).
17. Clean and prepare all of the surfaces as necessary for refinishing.
18. Apply the sealers. Refinish the surfaces as necessary.
19. Install and align all of the related panels and the components.
