K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
1. Install the motor to the cable housing by wiggling it into place.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the 3 bolts to the window motor.
Tighten
Tighten the bolts to 5 N.m (44 lb in).
3. Install the window, if removed.
4. Connect the wiring harness to the window regulator motor.
5. Remove the window support.
6. Connect the wire connector to the switch to inspect the operation of the window.
After inspection disconnect the wiring harness and continue the installation.
7. Install the speaker.
8. Install the water deflector.
9. Install the door trim panel.
