K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
1. Install the control rods to the assembly.
2. Connect the electrical connectors to the door lock actuator, if equipped.
3. Install the door lock actuator to the door.
4. Connect the outside door handle control rod.
5. Connect the cylinder lock rod.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the bolts which retain the door lock actuator to the door.
Tighten the screws to 9 N.m (80 lb in).
7. Connect the manual door lock to the door retainer clips.
8. Connect the inside door handle control rod to the lock assembly.
9. Connect the inside door lock rod to the handle retainer clip.
10. Install the water deflector.
11. Install the door trim panel.
12. Inspect the operation of all the related components.
