K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Power Mirror Switch: Service and Repair
Power Accessory Switch Panel Replacement
REMOVAL PROCEDURE
1. Insert a flat-bladed tool into the slots on the power accessory switch panel in order to release the retainer clips.
2. Remove the switch panel.
3. Disconnect the electrical connectors from the switches.
4. Remove the screws from the switches.
5. Remove the power accessory switches from the switch panel.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the power accessory switches to the switch panel.
Tighten
Tighten the power accessory switch screws to 2 N.m (18 lb in).
2. Connect the electrical connectors to the switches.
3. Position the switch panel to the door panel.
4. Install the switch panel by pressing the switch panel into place until fully seated.
