K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
11. Remove the rear base fasteners (2) from the vehicle.
12. Remove the rear bases with pads from the vehicle.
Installation Procedure
1. Install the rear bases with pads attached to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the rear base fasteners (2).
Tighten the rear base fasteners to 2 N.m (18 lb in).
3. Install the center supports with pads to the vehicle.
4. Install the support fasteners.
Tighten the support fasteners to 3 N.m (27 lb in).
5. With an assistant, lift the carrier (1) to the vehicle roof.
6. With an assistant, set the carrier assembly rails on the rear support assembly and pull forward, locking the carrier to the supports.
