K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
2. Release the J clip on the rear of the seat cushion and pull back the trim cover far enough to expose the side bolts (2).
3. Remove the cushion side bolts.
4. Disconnect the seat pull strap cable (3).
5. Remove the cushion from the seat.
6. Using a side motion, pull the remainder of the trim cover off the cushion.
7. Separate the foam pad from the cushion frame.
Installation Procedure
1. Attach the foam pad onto the cushion.
2. Carefully pull the trim cover over the cushion.
3. Connect the seat pull strap cable (3).
Notice: Refer to Fastener Notice in Service Precautions.
4. Before the cover is fully pulled over the frame, install the cushion side bolts (2) in order to attach the seat cushion to the seat.
Tighten the cushion side bolts to 35 N.m (26 lb ft).
5. Pull the trim cover over the remainder of the cushion.
6. Attach the J-clip on the rear of the seat cushion.
Ensure proper routing of the seat pull strap cable.
7. Install the rear seat into the vehicle.
Rear Seat Cushion Cover and Pad Replacement (Extended Cab)
Rear Seat Cushion Cover and Pad Replacement (Extended Cab)
Removal Procedure
1. Remove the rear seat from the vehicle.
